is it possible to make a flow to make a switch value switch to it opposite state.
ewelink rf single push switch is pressed.
this triggers a control switch to on via the rf hub.
the control switch is a redundant 1 channel switch.
once the 1ch control switch has been activated I wish to run ifttt command IF ewelink 1 ch on THEN
run stringify flow
the flow then runs and
THEN runs ifttt command
IF stringify flow THEN turn ewelink slampher light to opposite state.
I've tried using variables set to only if light is on flow. value light is 1 is on and 0 if off but couldn't get it to work.
tried using combination of switches and variables but to no avail.