Warning. Following these instructions could invalidate your manufacturers warranty. Stringify is providing these for informational purposes only. We, nor the companies mentioned, assume any liability if you follow these instructions. Proceed at your own risk and only perform these steps if you are qualified to do so.
Garageio is the simple and secure way to control and monitor your garage door from anywhere in the world, all without needing to replace your existing opener. The Garageio Blackbox can easily be installed in your home garage, allowing control of up to three separate garage doors.
The Garageio is a WiFI device that connects to your garage door opener, and lets you open or close your garage door as well as monitor its status.
While It is compatible with almost any automatic garage door opener connected to a sectional garage door, it did not work for my particular garage door. Simply connecting the Garageio to the trigger inputs on my garage door opener, as per the installation instructions, did not work:
However, there is a workaround to use the Garageio with Stringify, read on if interested...
As a reference, I have the LiftMaster MyQ model: 7675:
The following steps explain a workaround for this particular LiftMaster MyQ garage door opener to be controlled by the Garageio. The same approach may work for other garage door openers.
* Soldering iron.
* Safety glasses.
You will need to connect the control wires from the Garageio to the wall button directly instead of the garage for opener.
You will need to remove the wall button from the wall, open it and solder the wires to a surface mount circuit board button then re-assemble the button, re-install the wall button.
If your Garageio is plugged in, unplug it.
Locate the wall button and remove it. (You may have more than one, be sure to locate the correct one).
Once removed, turn it over, and you'll notice that it contains a small circuit board. (We will be soldering our Garageio wires to this board.)
Unscrew the two screws (in this case labeled Red and White) that connect the wires to your garage door opener.
Carefully remove the circuit board from the plastic housing, turn it over and note the small push button switch, in this case, labelled SW1. (We'll be soldering the Garageio wires to two legs of this switch.)
Solder the wires from the Garageio to the two legs on the switch as shown:
Note: You can use a multimeter to test the resistance of the two legs when the button is pressed to confirm the correct legs.
* Reassemble the wall button.
* Re-connect wires you removed in step 2.
* Mount and plug in the GarageIO. (Note: The Garageio can now be located by your wall button as I have done. If you wish to have it next to your garage door opener instead, simply run a long pair of wires from the wall button to the Garageio wires. In other words, you are simply extending the length of the Garageio wires to reach from your garage door to the wall button).
* Pair to your Z-Wave hub if not already done.
* Test to be sure it functions as expected.
Swiping the garage door within the app, now operates the garage door as expected.
You can now add the Garageio to Stringify...
...and use it in your flows.
In this flow example, "If it is night time, and I open my garage door, turn on my lights to welcome me home."
Here's the flow link if you'd like to try it out for yourself: